Star Trek 60th Anniversary GB - SNW Romulan Bird Of Prey

[ShawnMcClure]

I like this kit, so much better then the original kit. Might have to try and find this one myself.

It’s a fun build so far. You do have to use a resin printer for the wings though. They don’t print correctly in an FDM printer. Here is where I found the model: https://modelwerkshop.com/

 

[Veedubb67]

Might have to try and find this one myself.

It was just on sale over at Model Werks

1/1000 PIC ROM BOP Physical 3D Printed Kit

1/1000 3D printed full model kit. Kits are being produced on a first come, first serve basis. Please allow 4-6 weeks for delivery. This kit allows you to build the retconned Romulan BOP as seen in Picard and Strange New Worlds. This is a multipart kit that can be lit if desired. There is a...

modelwerkshop.com

 

[Kenny Conklin]

Small steps are better than no steps light is look good

 

[ShawnMcClure]

It was just on sale over at Model Werks

1/1000 PIC ROM BOP Physical 3D Printed Kit

1/1000 3D printed full model kit. Kits are being produced on a first come, first serve basis. Please allow 4-6 weeks for delivery. This kit allows you to build the retconned Romulan BOP as seen in Picard and Strange New Worlds. This is a multipart kit that can be lit if desired. There is a...

modelwerkshop.com

You can buy the STL files for cheaper. Good STL’s, but you need to print the wings on a resin printer. The filament printer just screws it up. I’m thinking of using a .2mm printer head in the filament printer and see if that works.

 

[ShawnMcClure]

Small steps are better than no steps light is look good

Thank you Kenny. Getting there.

 

[ShawnMcClure]

Hi all. I’m making more progress. I abandoned the cutting in half of the nacelles and printed the bodies whole. The nacelles are done and mocked up.